Goal: The wound is cleaned and protected with a dressing without contaminating the wound area, without causing trauma to the wound, and without causing the patient to experience pain or discomfort.
1. Review the medical orders for wound care or the nursing plan of care related to wound care.
2. Gather the necessary supplies and bring to the bedside stand or overbed table.
3. Perform hand hygiene and put on PPE, if indicated.
4. Identify the patient.
5. Close curtains around bed and close door to room if possible. Explain what you are going to do and why you are going to do it to the patient.
6. Assess the patient for possible need for nonpharmacologic pain-reducing interventions or analgesic medication before wound care dressing change. Administer appropriate prescribed analgesic. Allow enough time for analgesic to achieve its effectiveness.
7. Place a waste receptacle or bag at a convenient location for use during the procedure.
8. Adjust bed to comfortable working height, usually elbow height of the caregiver (VISN 8, 2009).
9. Assist the patient to a comfortable position that provides easy access to the wound area. Use the bath blanket to cover any exposed area other than the wound. Place a waterproof pad under the wound site.
10. Check the position of drains, tubes, or other adjuncts before removing the dressing. Put on clean, disposable gloves and loosen tape on the old dressings. If necessary, use an adhesive remover to help get the tape off.
11. Carefully remove the soiled dressings. If there is resistance, use a silicone-based adhesive remover to help remove the tape. If any part of the dressing sticks to the underlying skin, use small amounts of sterile saline to help loosen and remove.
12. After removing the dressing, note the presence, amount, type, color, and odor of any drainage on the dressings. Place soiled dressings in the appropriate waste receptacle. Remove your gloves and dispose of them in an appropriate waste receptacle.
13. Inspect the wound site for size, appearance, and drainage. Assess if any pain is present. Check the status of sutures, adhesive closure strips, staples, and drains or tubes, if present. Note any problems to include in your documentation.
14. Using sterile technique, prepare a sterile work area and open the needed supplies.
15. Open the sterile cleaning solution. Depending on the amount of cleaning needed, the solution might be poured directly over gauze sponges over a container for small
cleaning jobs, or into a basin for more complex or larger cleaning.
16. Put on sterile gloves.
17. Clean the wound. Clean the wound from top to bottom and from the center to the outside. Following this pattern, use new gauze for each wipe, placing the used gauze in the waste receptacle. Alternately, spray the wound from top to bottom with a commercially prepared wound cleanser.
18. Once the wound is cleaned, dry the area using a gauze sponge in the same manner. Apply ointment or perform other treatments, as ordered.
19. If a drain is in use at the wound location, clean around the drain. Refer to Skills 8-7, 8-8, 8-9, and 8-10.
20. Apply a layer of dry, sterile dressing over the wound. Forceps may be used to apply the dressing.
21. Place a second layer of gauze over the wound site.
22. Apply a surgical or abdominal pad (ABD) over the gauze at the site as the outermost layer of the dressing.
23. Remove and discard gloves. Apply tape, Montgomery straps or roller gauze to secure the dressings. Alternately, many commercial wound products are self adhesive and do not require additional tape.
24. After securing the dressing, label dressing with date and time. Remove all remaining equipment; place the patient in a comfortable position, with side rails up and bed in the lowest position.
25. Remove PPE, if used. Perform hand hygiene.
26. Check all wound dressings every shift. More frequent checks may be needed if the wound is more complex or dressings become saturated quickly.
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment